Matrix PRASAR UCS - System Timers and Counts

1152 Matrix PRASAR UCS System Manual
System Timers and Counts
What’s this?
Several features of the PRASAR UCS are based on Timers and Counts. For example, how long and how many
times an extension should ring when Message Wait is set, or how long the Busy Tone, the Ring Back Tone, or the
Error Tone should be played to an extension. PRASAR UCS allows you to configure most of these Timers and
Counts to suit your requirement.Listed below are the Timers and Counts related to the various features and
facilities, along with a brief description and default value of each.
Auto Redial
Call Progress Tones
Name Description Range Default
Auto Redial - Ring Back
Tone Wait Timer (sec.)
The time for which system waits to sense the Ring
Back Tone from the SIP Trunk service Provider after
dialing the requested number.
1 to 255 60 seconds
Auto Redial - Ring Timer
(sec.)
The time for which the extension that has requested
Auto Redial should ring.
1 to 255 45 seconds
Auto Redial - Normal
Timer (sec.)
The time interval between auto redial attempts when
Auto Redial ‘Normal’ is set.
1 to 255 45 seconds
Auto Redial - Normal
Count
The number of auto redial attempts the system will
make when Auto Redial ‘Normal’ is set.
1 to 255 5 Attempts
Auto Redial - Priority Timer
(sec.)
The time interval between auto redial attempts when
Auto Redial ‘Priority’ is set.
1 to 255 10 seconds
Auto Redial - Priority
Count
The number of auto redial attempts the system will
make when an extension having the feature Auto
Redial Priority in its Class of Service uses Auto Redial
‘Priority’.
1 to 255 20 Attempts
Name Description Range Default
Dial Tone Timer (sec) The time for which the system plays the Dial tone. 2 to 255 7 seconds
Ring Back Tone Timer
(sec)
The time for which the system plays the Ring Back
Tone.
2 to 255 45 seconds
Busy Tone Timer (sec) The time for which the system plays the Busy Tone. 1 to 255 7 seconds
Error Tone Timer (sec) The time for which the system plays the Error Tone. 1 to 255 30 seconds
Feature Confirmation
Tone Timer (sec)
The time for which the system plays the Confirmation
Tone when a feature is set or canceled.
1 to 255 7 seconds
Programming Error Tone
Timer (sec)
The time for which the system plays the Error Tone
when you have entered an invalid command string
while configuring a feature from a phone.
1 to 255 3 seconds