Matrix PRASAR UCS System Manual 799
Dial Plan for SIP Extension
What's this?
PRASAR UCS supports 8 Dial Plans with total 32 entries in each table. The Dial Plan contains a series of digits
and/or wild card characters.
When a user dials a number, it is compared with the Rule configured in the Dial Plan. If a match is found, the IP
Phone routes the call immediately without waiting for End of Dialing and if a match is not found, the IP Phone will
wait for the End of Dialing and then route the call.
How to configure
Configuring the Dial Plan involves the following steps:
• Selecting a Dial Plan and configuring the rules in the Dial Plan.
• Assigning the Dial Plan to the desired SIP Extensions.
Configuring Dial Plan using Jeeves
• Login as System Engineer.
• Under Configuration, click Dial Plan for SIP Extension.
• Click the desired Dial Plan number. The Dial Plan for SIP Extension - VP110/VP710 page opens.
• Against each Index configure the Rule according to which you want the system to process the call. You
can configure a maximum of 32 Rules in each Dial Plan.
To Next Page
Loading...