Matrix PRASAR UCS - Last Number Redial

Matrix PRASAR UCS System Manual 933
Last Number Redial
What’s this?
The system redials the last number string (external/internal) dialed from an extension. By default the system stores
only the external numbers in the Last Number Redial List. If you want the system to store internal calls in this list,
make sure you enable the Store Internal Calls in Redial Call Log check box in the “System Parameters”.
How it works
• Extension A dials the feature access code for ‘Redial’.
• The last 16 external numbers dialed by Extension A are displayed on the phone’s LCD.
• Extension A may select the number to be dialed out. The system will dial out this number using the same
trunk access code used for dialing this number.
• If Extension A has ‘Dynamic Lock’ set and uses Redial feature, the system will check for Toll Control as
per the Lock Level set for Extension A before dialing out the number.
How to configure
No particular configuration is required for this feature to work. Redial is included in the Basic Features allowed to all
extensions by default in their “Class of Service (COS)”. So, all extensions can use the Redial feature.
How to use
For Extended IP Phone Users
• Press Redial Key.
Or
•Dial 7.
A List of last 16 external numbers dialed will appear on your phone’s display.
• Scroll to select the desired number.
• Press Enter key.
• The system dials out the external number.