Matrix PRASAR UCS - System Administrator Mode

90 Matrix PRASAR UCS System Manual
• Click Submit to save your new password. The Welcome page will open.
As this password is meant for restricting access to the SE mode, we strongly recommend you to:
• Keep the password confidential.
• Select a complex password that cannot be easily guessed.
• Change the password regularly. See “System Security”.
• In case you forget the SE password, you must restore the default SE password. To do so, refer “Forgot
the SE Password?”.
• Do not use the “Remember Password” property of your Web Browser.
• Each login session into the SE Mode is set to 60 minutes by default. So, the login session will expire at
the end of 60 minutes.You can change the login session according to your preference by changing
Web Interface Logout Timer. To do so, refer “System Timers and Counts”.
• It is possible for four users to simultaneously log into the System Engineer Mode of Jeeves.
System Administrator Mode
At the System Administrator level, the settings of the features for the Extension users can be changed and
various system activity logs and reports such as system fault log reports, system activity logs, Station
Message Detail Recording reports and Hotel reports can be captured and printed.
The System Administrator may be the operator or receptionist, or any one responsible for the operation and
maintenance of the system.
The access to SA mode is protected by means of a password, referred throughout this document as the SA
password. Four persons can simultaneously login and change the system settings from the SA mode.
To be able to access Jeeves,
• the Ethernet Port of SPARK200 must be connected with a stand-alone PC or in a LAN.
• a web-browser, either Internet Explorer 7 or later or Mozilla Firefox 3.5.1 or later, must be installed on the
PC.
To log into the SA Mode,