Matrix PRASAR UCS System Manual 1159
• Under Configuration, click Change SE Password.
• Under For Programming from Extensions,
• Enter Current Password.
• Enter New Password. The new password can be a minimum of 4 digits to a maximum of 12 digits. The
valid digits are from 0 to 9.
•In Confirm New Password, re-enter the new password to confirm.
• Click Submit to save your new password.
Forgot the SE Password?
If you have already changed the default SE-Password for accessing Jeeves and are unable to recall or locate it,
you must restore the default SE password.
Restoring Default SE Password
You can restore the Default SE Password using the Reset Switch. Follow the instructions given below.
• Continuous press of Reset Switch for minimum 5 seconds and then release
• The SE password is set to default, however the following parameters are also set to default:
• Web Server Port
• Allow Remote Login
• IP Address, Sub-net and Gateway of LAN Port and WAN Port.
• DNS
• Network Port
To Next Page
Loading...