EasyManua.ls Logo

Matrix PRASAR UCS - Page 1169

Matrix PRASAR UCS
1368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1160 Matrix PRASAR UCS System Manual
Dynamic DNS
Router's Public address
•STUN
•VLAN
Allow Web Server Access value and Allow Web Server check box
The default SE password will be restored to 1234. You can now change the SE password again using
Jeeves.
When you press the Reset Switch the system provides an LED indication by turning on the LED in orange
- 500 msec On - 500 msec Off (Continuous) until the reset switch is released. When the Reset Switch is
released the LED will stop blinking.
This event is also logged in the System Activity Log. For details refer “System Activity Log”.
System Administrator (SA) Password
You can log into the SA mode through Jeeves or from extensions only after you have set the password
from SE mode through Jeeves. For more information, see “System Administrator Mode”.
For Accessing Jeeves
The SA password is a code for preventing unauthorized access to the SA mode. As this password is meant for
restricting access to the SA mode, we strongly recommend you to:
Keep the password secret.
Select a complex password that cannot be easily guessed.
Change the password regularly
Not use the “Remember Password” property of your Web Browser.
The SA password can be changed using Jeeves only and it must be as per the specifications given below:
It must be a minimum of 6 characters and a maximum of 12 characters.
It must include atleast one upper-case, one lower-case, one number and one special character.
All ASCII characters (except Percentage %, Hash #, Equal to =, Plus +, And &, Backslash \, Less than <,
Greater than >, Apostrophe ’, Double Quote " and Space) are allowed.
To provide additional security,
the password will be valid for 90 days and you will not be able to login with the existing password. You will
be prompted to change the password.
if you enter a wrong password five times consecutively within 10 minutes, the system will block the source
IP Address for 10 minutes. This activity will be logged in the “System Activity Log” as well as “Simple
Network Management Protocol (SNMP)”.
Changing SA Password using Jeeves
Login as System Administrator.

Table of Contents

Other manuals for Matrix PRASAR UCS