Matrix PRASAR UCS - The Interfaces

10 Matrix PRASAR UCS System Manual
The Interfaces
The PRASAR UCS supports the following interfaces.
LAN Interface
The LAN Port is provided to connect:
• the system to a PC or a LAN. This port is used for operating the web-based programming software Jeeves.
• the Local Area Network to register SIP extensions through the LAN Port.
• set up and run software applications such as PMS and CAS on any PC on the LAN.
• generate Station Message Detail Record (SMDR) Reports on any PC on the LAN.
• capture “System Activity Log”, “System Fault Log” and Hotel Motel Activity Log.
WAN Interface
The WAN Port is provided to connect:
• a LAN Switch/Hub/Router/Modem.
• the public network over a Router/Modem. Any user on the public network can be registered as SIP
Extension through the WAN Port.
• set up and run software applications such as PMS and CAS on any PC on the LAN.
• generate Station Message Detail Record (SMDR) Reports on any PC on the LAN.
• capture “System Activity Log”, “System Fault Log” and Hotel Motel Activity Log.
The VoIP Interface
The Voice-over-IP (VoIP) Interface connects PRASAR UCS with the internet or the private IP network. It enables
the PRASAR UCS to handle incoming and outgoing calls over the IP network. It offers great flexibility and mobility
to users for making or receiving calls across the world.
The VoIP Interface supports UC Clients, SIP Extensions and SIP Trunks.
With SIP Trunks users can make IP calls using the SIP Server of the Internet Telephony Service Providers (ITSPs).
• By default, one NX DBM VOCODER64 module is factory fitted. Each NX DBM VOCODER64 module
supports 64 VOCODER channels. You will be able to make and receive calls, but these will disconnect
after 60 seconds.
• To ensure call connectivity, you must purchase the application license — PRASAR UCS SME or
PRASAR UCS ENT. Both application licenses offer 8 pre-activated VOCODER channels. For more
channels, you must purchase the channel license according to your requirement. To know the license
details, see “Supported Licenses”.
The in-skin Registrar Server allows any SIP enabled device like a UC/SIP Soft Client or an IP-Phone to be
registered with it and function as the 'SIP Extension' of PRASAR UCS. The SIP Extension users can make and
receive calls to any extension user of the PRASAR UCS as well as any external numbers over VoIP. With SIP
Extensions, organizations can communicate and stay connected at the lowest cost without any geographical
restrictions.
The VoIP Interface supports adaptive jitter buffer for reducing delay and improving speech quality.