1278 Matrix PRASAR UCS System Manual
Session Manager Debug
Matrix PRASAR UCS supports a feature by which SE can view the Session Manager debugs on the server over IP
network. This is done by 'Syslog Client' in the PRASAR UCS which supports multiple debug levels.
Configuring Session Manager Debug using Jeeves
• Login as System Engineer.
• Under Maintenance, click Debug.
• Click Session Manager.
• Configure the following:
• Select the Debug check box to enable.
• Configure Syslog Server IP Address and Port.
Both IPv4 and IPv6 addresses are supported. By default, the Port is 514. Valid range of the port is from
1025 to 65535 and 514.
• Now, select the respective Debug Level check box to enable:
• System
•Serial
•SIP
•Call
• SIP Extension
• SIP Trunk
•BLF/MWI
• Presence
•IM
• Redundancy
Advance Debug Levels
•SIP
To Next Page
Loading...