Matrix PRASAR UCS System Manual 99
Configuring Network Parameters
PRASAR UCS has a LAN and WAN Port. The network parameters must be configured according to your network
scenario.
PRASAR UCS may be installed typically, in a Public IP Network or in a Private Network, behind a NAT Router.
When the PRASAR UCS is installed in a Public IP Network,
• the WAN Port is connected to a Broadband Router/Modem.
• Public IP is assigned to the WAN Port.
• the LAN Port is connected to a LAN Switch/Hub to which SIP devices are connected.
When the PRASAR UCS is installed in a Private Network, behind a NAT Router,
• the WAN Port is connected to the LAN Switch/Hub.
• Private IP is assigned to the WAN Port.
• SIP devices within the LAN can get registered with the system.
When your system is installed in a Private Network, you may have to change the IP Address and Subnet
Mask of the WAN Port, before connecting it to the LAN Switch/Hub. However, this will not be necessary, if
there is a DHCP server on the LAN which will automatically assign an IP Address that does not conflict
with any other device on the LAN.
Depending on your installation scenario, configure the Network Parameters.
Configuring Network Parameters using Jeeves
• Login as System Engineer.
• Under Configuration, click Network Parameters.
• Click Parameters.
To Next Page
Loading...