100 Matrix PRASAR UCS System Manual
Network Port
Click Network Port to expand.
• IP Addressing mode: Select the IP version you want the system to use. You may select — IPv4 only or
IPv4 and IPv6. Default: IPv4 only.
If you select IPv4 only, you can configure the IPv4 parameters only.
If you select IPv4 and IPv6, you can configure both IPv4 and IPv6 parameters.
• Preferred DNS Server: If you select IPv4 and IPv6 as the IP Addressing mode, you must select the
Preferred DNS Server — IPv4 or IPv6. Default: IPv4
LAN Port (IPv4 settings)
Make sure that the Redundancy LAN IP Address configured in “Configuring Redundancy Parameters” and
LAN Port IP Address are in the same subnet if you wish to use Redundancy.
To Next Page
Loading...