1060 Matrix PRASAR UCS System Manual
Selective Port Access
What’s this?
The system supports different extension and trunk port types. In the Selective Port Access feature, each port type
is assigned a Port Access Code. Extension users can access a particular port by dialing the Port Access Code
assigned to the Port and its Port Number.
How it works
• Extension user A wants to access a particular SIP Trunk port, SIP Trunk Port 1 to make a call. Extension A
must dial the Selective Port Access Feature Code, followed by the Port Type Code for SIP Trunk ports and
then dial the Port Number.
• The following access codes are assigned to each Port Type:
Here, Extension A must dial 69-15-01, where 69 is the feature code for Selective Port Access, 15 is the
port access code for the SIP Trunk Port, and 01 is the number of the SIP Trunk Port which A wants to
access.
Similarly, if Extension A wants to call SIP Extension 10, A can dial 69-19-010.
How to configure
To be able to use Selective Port Access, extension users must have this feature enabled in their “Class of Service
(COS)”.
How to use
For Extended IP Phone Users
To enable Selective Port Access on an extension,
• Press DSS key assigned to Selective Port Access code
• From the menu select the Port Type
• Enter the Port Number of the selected Port Type
OR
• Dial 69 / 89 (for users in USA)
• Dial the Port Type - Port Number
Port Types Port Access Code Port Numbers
SIP Trunk 15 01 to 99
SIP Extension 19
001 to 2100
a
a. PRASAR UCS SME Application License supports 250 SIP Extensions.
Virtual Extension 20 01 to 64
To Next Page
Loading...