Matrix PRASAR UCS - VMS Debug

Matrix PRASAR UCS System Manual 513
VMS Debug
The VMS supports debug for the VMS Application and SMTP. You can view debug messages on the Syslog
Server
74
.
To be able to use Syslog for debug, you will need to configure the Syslog Server Address and the Server Port on
which Syslog will listen for the debug messages.
Configuring VMS Debug using Jeeves
• Login as System Engineer.
• Under Configuration, click VMS Configuration.
• Click the Debug.
• Select the Enable Debug check box if you wish to view the VMS Debug
•In Syslog Server IP Address, configure the IP Address of the Syslog Server.
•In Syslog Server Port, configure the address of the Listening Port of the Syslog Server. Valid port
range is: 1025 to 65535; 514. By default, the remote server port address is '514'.
If you disable the check box, the system will not send the VMS Debug to the Syslog Server.
74. The PRASAR UCS supports Syslog Client, which enables the VMS to send debug messages in syslog format to the remote 'Sys-
log Server' on the IP network. You can view the system debug messages on the remote Syslog server or any other application
which can capture the Syslog debug messages.