Matrix PRASAR UCS System Manual 797
Dialed Number Directory
What's this?
Dialed Number Directory feature is available only to the users of the Extended IP Phones.
It is the list of numbers dialed out from the phone, similar to the call history of recently dialed calls on a cell phone.
PRASAR UCS retains up to 16 numbers dialed out from a phone in a directory.
These numbers may have been dialed out using features like Abbreviated Dialing, Quick Dial, Redial, Walk-In
Class of Service, or may be a simple outgoing call made by directly dialing the external number.
How it works
• When a IP Phone extension user makes an outgoing call, the number is stored in the Redial Number List.
By default the system stores only the external numbers in the Last Number Redial List. If you want the
system to store internal calls in this list, make sure you enable the Store Internal Calls in Redial Call Log
check box in the “System Parameters”.
• The list has a capacity of storing a maximum of 16 recently dialed numbers.
• The list is updated using the First-In First-Out logic, whereby the earliest dialed number is replaced with
the most recently dialed number.
• To use this feature, the phone user must invoke the “Last Number Redial” feature.
• Doing so, the Redial Number List will appear on the phone display.
• The user may now navigate the list, select the number to be dialed out.
• The system will dial out the selected number using the same Outgoing Trunk Bundle Group used to place
this call earlier.
• If the number had been dialed earlier using Abbreviated Dialing, the system will check for Toll Control
when dialing out the number again from the dialed number directory
111
.
How to configure
No specific programming required.
111. Recall that the system does not check for Toll Control when Abbreviated Dialing is used.
To Next Page
Loading...