Matrix PRASAR UCS System Manual 985
Outgoing Trunk Bundle
What’s this?
The Outgoing (OG) Trunk Bundle is set of parameters that completely define the grouping of the SIP trunks. These
Bundles are further used to form an OGTBG. The PRASAR UCS supports 128 OG Trunk Bundles.
Configuring OGTB using Jeeves
• Login as System Engineer.
• Under Configuration, click OG Trunk Bundle.
Configure the following parameters for each Bundle Number:
• Trunk Type: You can select SIP Trunk or None
• Trunk Number: If you have selected SIP Trunk as the Trunk Type, enter the SIP Trunk number from which
you want to begin the grouping here.
• Total Trunk Count: Multiple trunks can be there in a single group. Enter the maximum number of trunks
you want in a group here. For example if you have entered the Trunk number as 2 and the total as 10, then
trunks 2 to 11 will form one bundle.
• Rotation Type: This parameter shows which Trunk should be selected when the next call lands on that
port.
• Select Ascending if you want the system to check trunks from 01-99 to find a free trunk.
• Select Descending if you want the system to check trunks from 99-01 to find a free trunk.
• Select Cyclic, if you want the system to always select the next trunk for a new OG call.
• ANT Apply: Select the check box if you wish to use ANT feature. By default it is disabled.
To Next Page
Loading...