Matrix PRASAR UCS System Manual 87
CHAPTER 4
Configuring Basic PRASAR
UCS Settings
The PRASAR UCS can be configured through a web-based graphic user interface (GUI), called Jeeves.
For the list of SE commands, please contact Technical Support.
PRASAR UCS provides a Graphic User Interface (GUI), Jeeves, the proprietary web-based configuration software
of Matrix. It is a web server built into the PRASAR UCS.
Jeeves allows system configuration at three levels:
• System Engineer
• System Administrator
• Front Desk User
A distinct set of features and facilities can be configured at these levels. The accessibility to these two levels is
secured by a password. These passwords can be changed using Jeeves only.
It is possible to configure PRASAR UCS from any location using Jeeves. You can use Jeeves to configure
the system On-site (where it is installed) and Off-site, from a remote location.
System Engineer Mode
At the System Engineer level, the entire system configuration, all configurable features and facilities of the
PRASAR UCS can be changed to match user requirements and preferences.
To be able to do this, the System Engineer must enter the System Engineer (SE) configuration mode, by
logging into Jeeves as System Engineer.
Only the System Engineer, who installs, configures and maintains the system is allowed access to this mode.
Hence access to the SE mode is protected by means of a password, referred throughout this document as the
SE Password.
To be able to access Jeeves,
• the Ethernet Port of SPARK200 must be connected with a stand-alone PC or in a LAN.
• a web-browser, either Internet Explorer 7 or later or Mozilla Firefox 3.5.1 or later, must be installed on the
PC.
To log into the SE Mode,
To Next Page
Loading...