1266 Matrix PRASAR UCS System Manual
Network Diagnosis
What's this?
PRASAR UCS provides you an option to check the Internet/WAN connectivity using Ping and Traceroute as the
diagnostic tools.
How to Configure
• Login as System Engineer.
• Click the Maintenance link.
• Click the Network Diagnosis link.
•In Diagnostic Utility, select the diagnostic tool — Ping or Traceroute — to check the Internet/WAN
connectivity.
•In IP Address/Domain Name, enter the IPV4 or IPV6 Address or the Domain Name of the system whose
connectivity you wish to test. Default: Blank
If you have selected Ping as the Diagnostic Utility option, configure the following parameters:
•In Ping Packet Size, enter the number of bytes you want the system to send for Ping test. Valid Range:
4 to 1024. Default: 32 bytes.
•In Ping Count, enter the number of times you want system to send the request message for Ping test.
Valid Range: 1 to 50. Default: 4 times.
•In Ping Timeout (sec), enter the time for which you want the system to wait to get the response for
each request message sent. Valid Range: 1 to 9. Default: 3 sec.
To Next Page
Loading...