Matrix PRASAR UCS System Manual 1075
Static Routing Table
What's this?
Static Routing Table is required when:
• you have more than one router (gateway) in your network and you want PRASAR UCS to send packets to
multiple routers/gateways for different types of calls. These packets are routed through the WAN Port.
• you want route specific packets through the LAN Port.
Static Routing Table helps to route calls between point to point sites (connected through Multi Protocol Label
Switching-MPLS, Frame Relay, etc.) and to public internet at the same time.
How it works
Routing the packets through the WAN Port
For example, two Local Area Networks, Network A and Network B, are connected through Frame Relay/ Multi
Protocol Label Switching (MPLS) network to give access to local resources and also to make Peer-to-Peer calls.
At both sites PRASAR UCS is connected behind a router.
These sites are also connected to public IP network to:
• provide internet access to local hosts.
• access DID service provided by ITSPs to make calls over IP network.
To Next Page
Loading...