1074 Matrix PRASAR UCS System Manual
• Click SNTP to expand.
• Configure the following parameters under SNTP Client:
• Enable SNTP Client: Select this check box if you want the system to act as an SNTP Client. Default:
Enabled.
• SNTP Server Address: Enter the Time Server Address. SNTP Server address can be of maximum
64 characters. Both IPv4 and IPv6 addresses are supported. Default: time.nist.gov
• Synchronize Date and Time: You can Synchronize Date and Time with the SNTP Server on daily
or weekly basis. If you select weekly, the system will sync the date and time with the SNTP Server
on every Monday. Select the desired option as per your requirement. Default: Daily.
• Last Synchronized On: This field displays the time when the system last synchronized with the
SNTP Server.
• Sync Date and Time Server Now: Click this button to synchronize date and time of PRASAR UCS
with the SNTP server, whenever required.
SNTP Server
• Enable SNTP Server: Select this check box if you want the system to act as an SNTP Server and the
extensions (IP Phones) registered with it to behave as the clients. Default: Disabled.
• Click Submit.
To Next Page
Loading...