1064 Matrix PRASAR UCS System Manual
SMTP Settings
The Unified Messaging Functionality of PRASAR UCS includes using SMTP to send emails for the following
functions:
• activities logged in the System Activity Log (SAL)
• faults logged in the System Fault Log (SFL)
• VMS Notification, that is
• send notification to the extension users about the arrival of new messages (with/without Voice Mail
Attachment).
• send notification to the extension users about the memory usage status of their mailbox.
• memory usage notification to SE.
You can configure different account for each application. The systems allows you to configure a maximum of three
accounts.
For email transmission, you must:
• configure the parameter Message Wait Notification via Email
127
in the VMS settings of the extension. For
instructions, see “Email Based Notification”.
• configure the parameters VMS E-mail Notification and Use SMTP Account in VMS General Parameters.
For instructions, see “Configuring VMS General Parameters”.
• configure the parameters in System Log Notification for SAL and SFL. For instructions, see “System Log
Notification”.
• configure the SMTP Accounts and its parameters.
Configuring SMTP using Jeeves
• Login as System Engineer.
• Under Configuration, click SMTP Settings.
• By default no account is configured. You can add a maximum of three accounts. Click Add Account and
then configure the following parameters:
• Account Name: This will help to identify the application for which the account is being used.
127. You can also have the new voice message mailed as an attachment with the message wait notification.
To Next Page
Loading...