1274 Matrix PRASAR UCS System Manual
Health Monitor Debug
Matrix PRASAR UCS supports a feature by which SE can view the Health Monitor debugs on the server over IP
network. This is done by 'Syslog Client' in the PRASAR UCS which supports multiple debug levels.
Configuring Health Monitor Debug using Jeeves
• Login as System Engineer.
• Under Maintenance, click Debug.
• Click Health Monitor.
• Configure the following:
• Select the Debug check box to enable.
• Configure Syslog Server IP Address and Port.
Both IPv4 and IPv6 addresses are supported. By default, the Port is 514. Valid range of the port is from
1025 to 65535 and 514.
• Now, select the respective Debug Level check box to enable:
• System
• Health Monitoring
• Protocol
• Redundancy Process
As per the level selected, debug log will be generated.
• Click Submit.
To Next Page
Loading...