1276 Matrix PRASAR UCS System Manual
Media Server Debug
Matrix PRASAR UCS supports a feature by which SE can view the Media Server debugs on the server over IP
network. This is done by 'Syslog Client' in the PRASAR UCS which supports multiple debug levels.
Configuring Media Server Debug using Jeeves
• Login as System Engineer.
• Under Maintenance, click Debug.
• Click Media Manager.
• Configure the following:
• Select the Debug check box to enable.
• Configure Syslog Server IP Address and Port.
Both IPv4 and IPv6 addresses are supported. By default, the Port is 514. Valid range of the port is from
1025 to 65535 and 514.
• Now, select the respective Debug Level check box to enable:
•Basic
• Advance
• Information
• Resource
• Status
VoPP
• Command
• Event
•PCAP
As per the level selected, debug log will be generated.
To Next Page
Loading...