Matrix PRASAR UCS System Manual 101
Click LAN Port (IPv4 settings) to expand.
• IP Address: Enter the IP Address to be assigned to the LAN Port. The default IP Address is
192.168.002.100. You can assign only Static IP to the LAN Port.
• Subnet Mask: Enter the Subnet Mask to be assigned to the LAN Port. The default Subnet Mask is
255.255.255.0
WAN Port (IPv4 settings)
Make sure that the Redundancy WAN IP Address configured in “Configuring Redundancy Parameters”
and WAN Port IP Address are in the same subnet if you wish to use Redundancy.
Click WAN Port (IPv4 settings) to expand.
• Connection Type: Select the appropriate Connection Type for the WAN port, according to the IP
Addressing scheme of your installation scenario. Consult your Network Administrator in this regard.
Default: Static.
• Static: Select this option if the connection type is Static. When you select this option, you must:
• assign an IP Address to the WAN Port.
• change the Subnet mask of the WAN Port as appropriate.
• configure the Router's LAN Interface IP Address as the Gateway IP Address.
• Configure the DNS Address/Domain Name provided by your ISP or ask your LAN Administrator for
the DNS Address and Domain Name.
• DHCP: Select this option if the connection type DHCP. As the DHCP Server will automatically assign IP
Address, Subnet Mask, Gateway Address to the WAN Port, you need not configure any of these.
• PPPoE: Select this option if the connection type is PPPoE. As the PPPoE server will automatically
assign the IP Address, Subnet Mask and Gateway Address to the WAN Port, you need not change any
of these. You must program the User ID, Password and PPPoE Service Name as provided by your ISP.
Program the Service Name only if it has been provided. You must set DNS address.
Configure the following PPPoE parameters:
• User ID: Enter the User ID provided by the Internet Service Provider. The User ID may be a
maximum of 64 characters.
To Next Page
Loading...