Matrix PRASAR UCS System Manual 1153
Auto Attendant
Direct Inward System Access (DISA)
Message Notification
Programming
Confirmation Tone Timer
(sec)
The time for which the system plays the Confirmation
Tone when a system command is successfully
executed when configuring the system from a phone.
1 to 255 3 seconds
Call Forward - No Reply
Timer for Department
Group (sec)
The time for which the system will wait for an
extension (Department Group member) to answer an
incoming call, before forwarding the call to the
programmed destination.
1 to 255 30 seconds
Name Description Range Default
Auto Attendant Answer
Wait Timer (sec.)
The time for which the system waits before answering
a Auto Attendant call.
0 to 255 5 seconds
Auto Attendant Beeps
Timer (sec.)
The time for which the system plays beeps to the
caller to prompt the caller to dial the desired extension
number when the call is answered by the Auto
Attendant.
0 to 255 10 seconds
Auto Attendant Ring Timer
(sec.)
The time for which the system rings on the landing
destination extension in an Auto Attendant call.
1 to 255 30 seconds
Auto Attendant Error Tone
Timer (sec.)
In an Auto Attendant call, the time for which the
system plays Error Tone to the caller, if the caller has
dialed an invalid code.
1 to 255 5 seconds
Name Description Range Default
DISA Idle State Timer
(sec.)
In a DISA PIN Authentication call, the time for which
the system waits for the caller to go Off-hook after
entering DISA. If the caller does not go Off-hook within
this timer, the system releases the call.
0 to 255 20 seconds
DISA Inactivity Timer
(min.)
In a DISA call, the time for which the system waits for
the caller to dial digits. If the caller does not dial any
digit within this timer, the system disconnects the call.
0 to 255 2 minutes
Name Description Range Default
Message Notification
Retry Count
This count defines the number of times the system
must make Message Wait Notification Calls to the
destination number.
0 to 15 3 Attempts
Message Notification Ring
Timer (sec)
The time for which the extension on which the
Message Wait Notification Call is made will ring.
1 to 255 45 seconds
Message Notification
Interval (min)
This defines time interval between two retries. It is the
time after which the system must make another
attempt to place the notification call on the destination
1 to 255 5 minutes
Name Description Range Default
To Next Page
Loading...