Matrix PRASAR UCS - Page 1163

1154 Matrix PRASAR UCS System Manual
Other Features
Name Description Range Default
Auto Call Back Ring Timer
(sec.)
The time for which the extension requesting the Auto
Call Back and the destination extension will ring.
1 to 255 30 seconds
Interrupt Request Timer
(sec.)
The time for which the extension on which the Interrupt
Request is made will get the beeps.
1 to 255 45 seconds
Barge-In Timer (sec.)
The time after which the extension that has activated
Barge-In gets connected to the extension which is
barged in.
1 to 255 10 seconds
Transfer while Ringing
Timer (sec.)
When an extension transfers a call to another
extension after it starts ringing, this is the time for
which the system will wait for the transfer target
extension to answer the call. If the transfer target does
not answer the call within this timer, the call is returned
to the transferor.
1 to 255 30 seconds
Transfer on Busy Timer
(sec.)
When a call is transferred to a Busy extension, this is
the time for which beeps are played on the transfer
target extension.
1 to 255 30 seconds
Call Park Timer (min.)
The time after which the call comes back to the
extension that has parked the call.
2 to 255 2 minutes
Call Park Release Timer
(min.)
The time after which the parked call gets
disconnected.
1 to 255 3 minutes
Conflict Dialing Timer
(sec.)
The time for which the system waits for the extension
user to dial the next digit to resolve conflicting access
codes dialed by the extension user.
1 to 255 2 seconds
Extension - Inter Digit
Wait Timer (sec.)
The time for which the system waits for the extension
user to dial the next digit.On the expiry of this timer, the
system considers it as the end of number dialing.
2 to 255 7 seconds
SA Command - Inter Digit
Wait Timer (sec.)
When the user dials SA Commands, the system waits
for the SA Command - Inter Digit wait timer for the user
to dial the next digit.On the expiry of this timer, the
system considers it as end of number dialing and
proceeds further with executing the command.
2 to 255 15 seconds
Trunk - First Digit Wait
Timer (sec.)
The time for which the system waits for the extension
user to dial the first digit, after grabbing the trunk.
1 to 255 25 seconds
Trunk - Inter Digit Wait
Timer (sec.)
When an extension user has grabbed the trunk and is
dialing a number, the system waits for the Trunk-Inter-
Digit wait timer for the extension user to dial the next
digit. On the expiry of this timer, the system considers
it as end of number dialing and proceeds with the call.
1 to 255 3 seconds
Global Hold Retrieval
Timer (sec.)
This is the time for which a call put on Global Hold
remains connected in the system. If the call put on
Global Hold is not retrieved within this timer, the call is
returned to the Extended IP Phone which put it on
hold.
1 to 999 60 seconds