Matrix PRASAR UCS System Manual 1077
How to configure
The Static Routing Table must be configured at each location where PRASAR UCS is installed. You may configure
the Static Routing Table using Jeeves.
Configuring Static Routing Table using Jeeves
• Login as System Engineer.
• Under Configuration, click Network Parameters.
• Click Static Routing Table.
.The Static routing table allows you to configure upto 8 entries in each table, IPv4 Addresses table and
IPv6 Addresses. Each entry is stored against an Index number.
IPv4 Addresses Table
For each entry, you must configure the following fields:
• Destination Address: This is the address of the final destination where the call is to be made. This
can be a device IP Address or Network Address.
• Subnet Mask: This is the mask to be applied on destination address.
• Gateway Address: This is the IP address of the node where the IP packets are to be sent. Generally, it
is the IP address of the LAN interface of the Router.
The Gateway Address must be in the same subnet as PRASAR UCS.
Click Submit.
To Next Page
Loading...