1086 Matrix PRASAR UCS System Manual
• Click SMDR Reports
•For SMDR - Outgoing Call Report,
• Select the Destination Port. Default: None.
• If you select Ethernet as the Destination Port,
•In Destination IP Address, enter the IP Address of the remote Syslog Server. Both IPv4 and IPv6
addresses are supported.
•In Port, enter the port of the remote Syslog Server. Valid port range is: 514; 1025 to 65535.
•For SMDR - Incoming Call Report,
• Select the Destination Port. Default: None.
• If you select Ethernet as the Destination Port,
•In Destination IP Address, enter the IP Address of the remote Syslog Server. Both IPv4 and IPv6
addresses are supported.
•In Port, enter the port of the remote Syslog Server. Valid port range is: 514; 1025 to 65535.
•For SMDR - Internal Call Report,
• Select the Destination Port. Default: None.
• If you select Ethernet as the Destination Port,
•In Destination IP Address, enter the IP Address of the remote Syslog Server. Both IPv4 and IPv6
addresses are supported.
To Next Page
Loading...