Matrix PRASAR UCS System Manual 103
• DNS Domain Name: Configure the DNS Domain Name if provided by your ITSP/LAN Administrator.
Otherwise, keep it blank. The Domain Name may be a maximum of 40 characters. Default: Blank.
LAN Port (IPv6 settings)
Make sure that the Redundancy LAN IP Address configured in “Configuring Redundancy Parameters” and
LAN Port IP Address are in the same subnet if you wish to use Redundancy.
Click LAN Port (IPv6 settings) to expand.
• IPv6 Addressing using: You can select — Complete Address or Prefix. Default: Complete Address.
If you select Complete Address,
• Configure the IPv6 Address and the Prefix Length. The IP Address configured will be considered as
the complete IPv6 address.
For example: 2001:0:3238:DFE1:63::FEFB
The Prefix Length is a decimal value that indicates how many of the high-order contiguous bits of the
address comprise the prefix (the network portion of the address).
Valid Range of the IPv6 Address is A to F, a to f, 0 to 9,:(colon). It can be a maximum of 39 characters.
Default: Blank.
The Prefix Length range is from 1 to 128 bits. Default: Blank.
If you select Prefix,
• Configure the IPv6 Prefix. The system will consider the configured value as 64 bit Prefix of the IPv6
Address. Then the system will generate the complete IPv6 Address from it. Default: Blank.
Valid characters 0 to 9, a to f, A to F and : (colon). It can be a maximum of 21 characters.
WAN Port (IPv6 Settings)
Make sure that the Redundancy WAN IP Address configured in “Configuring Redundancy Parameters”
and WAN Port IP Address are in the same subnet if you wish to use Redundancy.
To Next Page
Loading...