112 Matrix PRASAR UCS System Manual
• Interval: Select Time period after which the WAN Port should send TCP NAT Keep Alive messages.
This time period should be less than the Binding Timer of the router. The valid range is 0001-9999
seconds. Default: 120 seconds.
Viewing Network Parameters
You can view the status of WAN Port in Jeeves. To do this,
• Login as System Engineer.
• Under Configuration, click Network Parameters.
• Click Status.
It displays the statuses of the various IPv6 and IPv4 parameters for the LAN and WAN port.
When the system receives the IP Address from the DHCP/ PPPoE Server, the system performs DAD (Duplicate
Address Detection). If DAD fails due to conflict in IP Address, the respective network parameters (WAN or LAN)
need to be re-initialized.
To re-initialize the WAN parameters, click the IPv4 Network Reinitialization or IPv6 Network Reinitialization
button under WAN. Similarly, to re-initialize the LAN parameters, click the IPv4 Network Reinitialization or IPv6
Network Reinitialization button.
You can also view the Network Status from the Status link. To view, click the Network link under Status.
To Next Page
Loading...