1262 Matrix PRASAR UCS System Manual
• Press Enter key. You get a confirmation message ‘Started!’
To stop PCAP,
• Enter the Local Menu of the phone again by pressing the DSS key.
• Enter the Network Parameters submenu.
• Select PCAP and press Enter.
• The message Stop PCAP appears on your phone display.
• Press Enter key. You get the confirmation message: ‘Stopped!’
• Go idle.
Using PCAP Trace for Matrix SPARSH VP310 Matrix Extended IP Phone
PCAP Trace supported by the Matrix Extended IP Phone can capture up to 1 MB of packets and store them in the
embedded FTP server of the phone.
You are not required to set any filters; the phone captures all packets that it sends and receives.
To use PCAP Trace,
• When the phone is in idle state, press the DOWN key to access the Network Settings.
PCAP TRACE
PCAP TRACE
PCAP TRACE
To Next Page
Loading...