132 Matrix PRASAR UCS System Manual
To do this, click the link CDC Table to open the page. Configure the CDC Table parameters and Submit to
save your settings. Now return to the Station Advanced Feature Template and enter the number of the
CDC Table you configured in the CDC Table of the template.
Refer the feature description “Call Duration Control (CDC)” to know more and for instructions on creating
CDC Tables.
• Route Global Directory Calls using: This parameter decides the OGTBG to be used to route the Global
Directory number. You may select either OGTBG configured in the Global Dir. or any other OGTBG
from 01 to 32.
• Department Billing Group: This parameter enables you to know the total cost of the calls made by a
particular group of extensions. This parameter is used as a one of the filters for printing SMDR Reports
namely, Print outgoing calls department group wise. To be able to use this filter, you must assign the
extensions to a Department Bill Group. You can create as many as 99 different Department Bill Groups.
Enter the number of the Bill Group you want to assign the extensions here. By default, no Routing Group is
assigned to Floor Service in the Template ('00').
• Floor Service Group: This parameter is related to the Floor Service feature. Floor Service can be floor-
wise or centralized. Floor Service requires you to configure the Routing Groups as landing destinations for
extension calls.
Configure the Floor Service (Routing) Group first and enter this Floor Service (Routing) Group number
here. There are 96 different Routing Groups that can be configured as Floor Service Groups. By default,
no Routing Group is assigned to Floor Service in the Template ('00').
To know more about this feature, refer the feature description for “Floor Service”.
Calls from the extension will land on the Floor Service (Routing) Group you have assigned here.
• GPAX - Charge Internal Calls: This parameter is related to the GPAX application. If the extension is
configured as a GPAX user, select this check box for billing internal calls made by the extension. When it is
enabled, the system will record all calls made from the extension in the Station Message Detail Record-
Outgoing buffer. If it is disabled the calls will not be billed and will be recorded in the Station Message
Detail Record - Internal buffer as an internal call.
• Assign Help Desk function: Select this check box, if you want to define the extension as “Help Desk”.
When it is enabled, Auto Call Back will be automatically set whenever this extension is found busy.
• Do not allow outgoing calls without Account Code: Select this check box to apply Forced Account
Code on the extensions. When it is enabled, the system will allow the extension user to dial an external
number only after entering the Account Code. To know more refer to “Account Codes”.
• Ringer LED: This parameter decides whether the Ringer LED should glow or not on the desired
extensions for incoming calls and as missed call notification. By default, the LED will continue to blink until
the missed call log is read or the call is answered/disconnected or the silent CSF Key
18
is pressed. Disable
this check box if you do not want the Ringer LED to glow.
18. Supported on SPARSH VP510 only.
To Next Page
Loading...