Matrix PRASAR UCS - Page 158

Matrix PRASAR UCS System Manual 149
• Speakerphone: The ring will be played on the Speakerphone.
• Headset: The ring will be played on the Headset.
Default: Speakerphone.
When you select the Headset as the destination, make sure that you selected the Headset Connected?
check box, connect a Headset to the SPARSH VP248.
• Select the desired Ring Tune according to your/SPARSH VP248 user’s preference. Default: 1.
• Set the Ringer Volume to the desired level, from 0 to 7, according to your preference. Default: 4.
• To increase/decrease the volume of outgoing speech (Transmit Gain) on the handset of the SPARSH
VP248, set the Handset Transmit Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of incoming speech (Receive Gain) on the handset of the SPARSH
VP248, set the Handset Receive Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of outgoing speech (Transmit Gain) on the headset of the SPARSH
VP248, set the Headset Transmit Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of outgoing speech (Receive Gain) on the headset of the SPARSH
VP248, set the Headset Receive Volume Level to the desired level, from 0 to 7. Default: 4.
• To change the Transmit Gain of the Speakerphone MIC Volume, set Speaker Transmit Volume Level to
the desired level, from 0 to 7. Default: 4.
• To change the Receive Gain of the Speakerphone MIC Volume, set Speaker Receive Volume Level to
the desired level, from 0 to 7. Default: 4.
• To use a Headset with the SPARSH VP248, select the Headset Connected? check box. Default:
Disabled.
Make sure that you connect a Headset to the SPARSH VP248, if you enable this option.
• Select the Auto Answer check box to enable this feature on the SPARSH VP248. Default: Disabled.
When you set the “Auto Answer” feature on the SPARSH VP248, the phone goes OFF-Hook automatically
after a preset period of time, without the extension user having to pick up the handset or press the speaker
or headset key. When you enable Auto Answer, you must configure the Auto Answer Timer.
• If you have enabled Auto Answer on the phone, set the Auto Answer Timer (sec) to the desired value.
This timer defines the time in seconds that the SPARSH VP248 should wait before going OFF-Hook to
auto answer a call. The range of this timer is 1 to 9 seconds. Default: 1 second.
• Adjust the Backlight brightness of the phone’s LCD display, by setting the LCD Backlight Level to the
desired value, from 1 to 4. Default: 3.
• Set the Back Light Off Timer (sec) to the desired value, if required, from 000 to 999 seconds. Default: 10
seconds.
• Set the LCD Contrast Level to a level from 1 to 4 that is comfortable to you. Default: 3.