Matrix PRASAR UCS - Page 177

168 Matrix PRASAR UCS System Manual
Default: Speakerphone.
When you select the Headset as the destination, make sure that you enable the Headset Connected?
check box. Connect a Headset to the SPARSH VP310.
• Set the Ringer Volume to the desired level, from 0 to 7, according to your preference. Default: 4.
• To increase/decrease the volume of outgoing speech (Transmit Gain) on the handset of the SPARSH
VP310, set the Handset Transmit Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of incoming speech (Receive Gain) on the handset of the SPARSH
VP310, set the Handset Receive Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of outgoing speech (Transmit Gain) on the headset of the SPARSH
VP310, set the Headset Transmit Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of outgoing speech (Receive Gain) on the headset of the SPARSH
VP310, set the Headset Receive Volume Level to the desired level, from 0 to 7. Default: 4.
• To change the Transmit Gain of the Speakerphone MIC Volume, set Speaker Transmit Volume Level to
the desired level, from 0 to 7. Default: 4.
• To change the Receive Gain of the Speakerphone MIC Volume, set Speaker Receive Volume Level to
the desired level, from 0 to 7. Default: 4.
• To use a Headset with the SPARSH VP310, select the Headset Connected? check box. Default:
Disabled.
Make sure that you connect a Headset to the SPARSH VP310, if you enable this option.
• Select the Auto Answer check box to enable this feature on the SPARSH VP310. Default: Disabled.
When you set the “Auto Answer” feature on the SPARSH VP310, the phone goes OFF-Hook automatically
after a preset period of time, without the extension user having to pick up the handset or press the speaker
or headset key. When you enable Auto Answer, you must configure the Auto Answer Timer.
• If you have enabled Auto Answer on the phone, set the Auto Answer Timer (sec) to the desired value.
This timer defines the time in seconds that the SPARSH VP310 should wait before going OFF-Hook to
auto answer a call. The range of this timer is 1 to 9 seconds. Default: 1 second.
• Adjust the Backlight brightness of the phone’s LCD display, by setting the LCD Backlight Level to the
desired value, from 1 to 4. Default: 3.
• Set the Back Light Off Timer (sec) to the desired value, if required, from 000 to 999 seconds. Default: 10
seconds.
• Set the LCD Contrast Level to a level from 1 to 4 that is comfortable to you. Default: 3.
DSS Key Settings
• You can select the desired key template — Operator, Executive1, Executive2, Executive3, Hotel
Attendant, Guest or any other template you added. See “Customizing Extended IP Phone Templates using
Jeeves” for more details.