Matrix PRASAR UCS - Page 193

184 Matrix PRASAR UCS System Manual
• Select MATRIX SPARSH VP330 as the Device Type at this location.
• Enter the MAC Address
31
of the SPARSH VP330 connected at this location in hexadecimal format:
00:1b:09:XX:XX:XX. Default: blank.
PRASAR UCS validates the SPARSH VP330 on the basis of the MAC Address, and provides configuration
on validation.
As PRASAR UCS allows registration of the SIP Extension from three different locations, it identifies the
SIP Extension in each location by the programmed MAC address.
• Select the appropriate Registrar Server Address to register the SPARSH VP330 with the SIP Registrar of
PRASAR UCS, according to your installation scenario:
• If the SPARSH VP330 is connected on the WAN network, select Use WAN Port IP Address as
Registrar Server IP Address.
• If the SPARSH VP330 is connected on the LAN network, select Use LAN Port IP Address as
Registrar Server IP Address.
• If the SPARSH VP330 is connected in the Global Network and PRASAR UCS is located behind a
Router, or behind a NAT Router and STUN is programmed, select Use Router/STUN's IP Address as
Registrar Server IP Address.
Make sure you configure either the Router’s Public IP Address or Simple Traversal of UDPs
through NATs (STUN) in Network Parameters. For details, see “Configuring Network Parameters”.
• If Dynamic DNS is configured in the Network Parameters, select Use Dynamic DNS Host Name as
Registrar Server IP Address.
By default, Use WAN Port IP Address is selected as the Registrar Server IP Address.
• To set the call progress tone generation standards of the country where the SPARSH VP330 is installed,
select the Call Progress Tone - Region. Default: Region 1.
See “Call Progress Tones” to know more.
• To display the Date and Time of the country where the SPARSH VP330 is installed, select the Date and
Time - Region. Default: India.
• If you want to enable Daylight Saving Time (DST) on the phone, set Apply DST? to either Manual or
Scheduled as per your requirement.
When you select Scheduled as the DST option, the Real Time Clock of PRASAR UCS is advanced and
set backward automatically according to the DST convention of the country/region where the IP Phone is
installed.
Scheduled DST Adjustment is useful in countries/regions where DST Time is fixed, such as in Europe,
USA and Canada, without yearly variations.
31. MAC address is the address of the electronic hardware devices such as a computer, which is hard-coded into the device during
manufacture and cannot be modified. No two devices can have similar MAC address and thus it uniquely identifies your phone.
MAC address is assigned as per the IANA standard. The MAC Address of the phone will be used as source MAC address on all
Ethernet frames.