Matrix PRASAR UCS - Page 210

Matrix PRASAR UCS System Manual 201
• Enter the Location Name for the phone to identify the phone. Location name may be the place where the
phone is located (e.g.: Head office, branch, residence). The Location Name may consist of 18 characters
(maximum). Default: Blank.
• Select MATRIX SPARSH VP510 as the Device Type at this location.
• Enter the MAC Address
36
of the SPARSH VP510 connected at this location in hexadecimal format:
00:1b:09:XX:XX:XX. Default: Blank.
PRASAR UCS validates the Extended Phone on the basis of the MAC Address, and provides
configuration on validation.
As PRASAR UCS allows registration of the SIP Extension from three different locations, it identifies the
SIP Extension in each location by the programmed MAC address.
• Select the appropriate Registrar Server Address to register the SPARSH VP510 with the SIP Registrar of
PRASAR UCS, according to your installation scenario:
• If the SPARSH VP510 is connected on the WAN network, select Use WAN Port IP Address as
Registrar Server IP Address.
• If the SPARSH VP510 is connected on the LAN network, select Use LAN Port IP Address as
Registrar Server IP Address.
• If the SPARSH VP510 is connected in the Global Network and PRASAR UCS is located behind a
Router, or behind a NAT Router and STUN is programmed, select Use Router/STUN's IP Address as
Registrar Server IP Address.
Make sure you configure either the Router’s Public IP Address or Simple Traversal of UDPs
through NATs (STUN) in Network Parameters. For details, see “Configuring Network Parameters”.
• If Dynamic DNS is configured in the Network Parameters, select Use Dynamic DNS Host Name as
Registrar Server IP Address.
By default, Use WAN Port IP Address is selected as the Registrar Server IP Address.
• To set the call progress tone generation standards of the country where the SPARSH VP510 is installed,
select the Call Progress Tone - Region. Default: Region 1.
See “Call Progress Tones” to know more.
• To display the Date and Time of the country where the SPARSH VP510 is installed, select the Date and
Time - Region. Default: India.
• If you want to enable Daylight Saving Time (DST) on the phone, set Apply DST? to either Manual or
Scheduled as per your requirement.
When you select Scheduled as the DST option, the Real Time Clock of PRASAR UCS is advanced and
set backward automatically according to the DST convention of the country/region where the IP Phone is
installed.
36. MAC address is the address of the electronic hardware devices such as a computer, which is hard-coded into the device during
manufacture and cannot be modified. No two devices can have similar MAC address and thus it uniquely identifies your phone.
MAC address is assigned as per the IANA standard. The MAC Address of the phone will be used as source MAC address on all
Ethernet frames.