Matrix PRASAR UCS - Page 212

Matrix PRASAR UCS System Manual 203
• Select the Trunk CLIP Pattern for the SPARSH VP510. This is the type of Calling Line Presentation on
the phone for incoming calls from trunks. You can select any of these options:
• Name Only (only the name of the caller will be displayed).
• Number Only (only the number of the caller will be displayed).
• Number + Name (both the name and the number of the caller will be displayed).
Default: Number + Name.
• Select the Display Language for the SPARSH VP510. Default: English.
PRASAR UCS provides language support for English, French, German, Spanish, Portuguese, and Italian
on the SPARSH VP510. When you select any of these languages, all the prompts and command strings
will appear in the selected language.
• SIP Extension users can change the language by accessing and navigating through the phone menu.
• The SA can change the Language by logging into the SA Jeeves.
• Select a Ringer Mode for the phone from the four options:
• Ring immediately (it rings immediately as a fresh calls lands on the phone).
• Ring if idle (rings only if the phone is idle).
• Ring after a delay (if the call is still not answered).
•Silent.
Default: Ring Immediate.
• If you selected Ring after a delay as Ringer Mode, set the Ring Delay Timer (sec), if required, to the
desired value.
The Ring Delay Timer is the time in seconds the system waits on receiving a call before ringing on the
phone. The range of this timer is 0 to 99 seconds. Default: 10 seconds.
• If you want to enable Ringer Auto Acknowledge mode, set the Acknowledge Timer (sec) to the desired
value.
The Ringer Auto Acknowledge mode determines when to stop the ring on the phone. There are two
options for Ringer Auto Acknowledge:
• Stop only when the call is answered.
• Stop after a delay.
To stop the ring on the phone after a delay, the Acknowledge Timer must be configured. The range of this
timer is 00 to 99 seconds. Default: 00 seconds.
To stop the ring only when the Call is answered or manually acknowledged, the Acknowledge Timer must
be set to '00'. By default, Ring Auto Acknowledge is turned OFF.
• To assign the Ring Destination for the SPARSH VP510, select the desired destination for Play Ring on.
You may choose
• Speakerphone: The ring will be played on the Speakerphone.
• Headset: The ring will be played on the Headset.
Default: Speakerphone.