212 Matrix PRASAR UCS System Manual
• If you have completed the configuration of the SPARSH VP510 Settings at Location 1, follow the same
steps as described above to configure the SPARSH VP510 at Location 2 and Location 3.
When you change any of the parameters listed below in the SIP Extension at Location 1, 2, 3, the phone
will restart automatically, if registered:
• Use SIP Extension
• SIP ID
• Authentication ID
• Authentication Password
• Registrar Server IP Address
• MAC Address
• Enable Device
• Device Type
• Key Map in the Key Template assigned to phone
• Call Progress Tone
• Date and Time
• Apply DST?
• Transport Mode and SRTP
•QoS
•RTP Ports
• NAT Keep Alive
• SIP Timers
• The SE Password of PRASAR UCS is changed
• Specific parameters in VoIP Parameters are changed
• Specific parameters in Network Port parameters are changed
• You restart the System
• Set the System to Default
To Next Page
Loading...