Matrix PRASAR UCS - Page 230

Matrix PRASAR UCS System Manual 221
• Select the Enable Device check box. Default: Disabled.
• Enter the Location Name for the phone to identify the phone. Location name may be the place where the
phone is located (e.g.: Head office, branch, residence). The Location Name may consist of 18 characters
(maximum). Default: Blank.
• Select MATRIX SPARSH VP710 - Extended SIP as the Device Type at this location.
• Enter the MAC Address
40
of the Extended SPARSH VP710 connected at this location in hexadecimal
format: 00:1b:09:XX:XX:XX. Default: Blank.
PRASAR UCS validates the Extended Phone on the basis of the MAC Address, and provides
configuration on validation.
As PRASAR UCS allows registration of the SIP Extension from three different locations, it identifies the
SIP Extension in each location by the programmed MAC address.
• Select the appropriate Registrar Server Address to register the Extended SPARSH VP710 with the SIP
Registrar of PRASAR UCS, according to your installation scenario:
• If the Extended SPARSH VP710 is connected on the WAN network, select Use WAN Port IP Address
as Registrar Server IP Address.
• If the Extended SPARSH VP710 is connected on the LAN network, select Use LAN Port IP Address
as Registrar Server IP Address.
• If the Extended SPARSH VP710 is connected in the Global Network and PRASAR UCS is located
behind a Router, or behind a NAT Router and STUN is programmed, select Use Router/STUN's IP
Address as Registrar Server IP Address.
Make sure you configure either the Router’s Public IP Address or Simple Traversal of UDPs
through NATs (STUN) in Network Parameters. For details, see “Configuring Network Parameters”.
• If Dynamic DNS is configured in the Network Parameters, select Use Dynamic DNS Host Name as
Registrar Server IP Address.
By default, Use WAN Port IP Address is selected as the Registrar Server IP Address.
• Select the Language for the Extended SPARSH VP710. Default: English.
PRASAR UCS provides language support for English, French, German, Spanish, Portuguese, and
Italian on the Extended SPARSH VP710. When you select any of these languages, all the prompts and
command strings will appear in the selected language.
SIP Extension users can change the language by accessing and navigating through the phone menu.
The SA can change the Language by logging into the SA Jeeves.
40. MAC address is the address of the electronic hardware devices such as a computer, which is hard-coded into the device during
manufacture and cannot be modified. No two devices can have similar MAC address and thus it uniquely identifies your phone.
MAC address is assigned as per the IANA standard. The MAC Address of the phone will be used as source MAC address on all
Ethernet frames.