EasyManua.ls Logo

Matrix PRASAR UCS - Page 232

Matrix PRASAR UCS
1368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Matrix PRASAR UCS System Manual 223
disconnects the call. On expiry of the timer, the phone terminates the call process and gives an error
tone to the user. The range of the SIP INVITE TIMER is 10-180 seconds. Default: 30 seconds.
SIP Provisional Timer (sec): This is the time in seconds that the phone waits for final response after
receiving the provisional response from the called party. This timer starts on the receipt of the
provisional response from the called party and stops on receipt of the final response from the called
party or when the user disconnects the call. On expiry of the timer, the IP phone terminates the call
process and gives error tone to the user. The range of SIP Provisional Timer is 10-180 seconds.
Default: 60 seconds.
General Request Timer (sec): This is the time in seconds for which the phone waits for response of a
transaction request. This timer starts on initiating a transaction. This timer stops on receipt of a
response for the request. On expiry of the timer, the phone clears the transaction. This timer is used for
Registration request, etc. The range of the General Request Timer is 10-60 seconds. Default: 20
seconds.
Click Submit to save settings.
If you have completed the configuration of the Extended SPARSH VP710 Settings at Location 1, follow the
same steps as described above to configure the Extended SPARSH VP710 at Location 2 and Location 3.
When you change any of the parameters listed below in the SIP Extension at Location 1, 2, 3, the phone
will go in Auto Configuration mode automatically, if registered:
Use SIP Extension
SIP ID
Authentication ID
Authentication Password
Registrar Server IP Address
MAC Address
Enable Device
Device Type
Transport Mode and SRTP
•QoS
•RTP Ports
NAT Keep Alive
SIP Timers
Class of Service
Trunk Access Code
The SE Password of PRASAR UCS is changed
Specific parameters in VoIP Parameters are changed
Specific parameters in Network Port parameters are changed
You restart the System
Set the System to Default

Table of Contents

Other manuals for Matrix PRASAR UCS