244 Matrix PRASAR UCS System Manual
• The settings of the phone at Location 1 appear.
• Select the Enable Device check box. Default: Disabled.
• Enter the Location Name for the phone to identify the phone. Location name may be the place where the
phone is located (e.g.: Head office, branch, residence). The Location Name may consist of 18 characters
(maximum). Default: Blank.
• Select MATRIX VARTA ADR100/AMP100 (for the Android/iPhone Application) as the Device Type at this
location. Make sure you assign the desired license to this SIP extension. For details, see “VARTA License
Management”.
• Enter the MAC Address/IMEI
46
/ESN Number of the phone/tablet on which you have installed the
application.
If you are using an iPhone, enter the Device ID here. Default: blank.
PRASAR UCS validates the phone/tablet on which you have installed the application on the basis of the
IMEI/ESN Number or Device ID, and provides configuration on validation.
As PRASAR UCS allows registration of the SIP Extension from three different locations, it identifies the
SIP Extension in each location by the programmed IMEI/ESN Number/Device ID.
• Select the appropriate Internal Registrar Server Address to register the application with the SIP
Registrar of PRASAR UCS within a private network. Select the appropriate option as per your installation
scenario:
46. IMEI Number is the unique identification number of the GSM engine used in the Mobile handset.
To Next Page
Loading...