Matrix PRASAR UCS System Manual 259
After you upload the CSV File, the following statuses will be displayed:
• Successful: The total number of extensions that are successful configured in the server.
• Failed: The total number of extensions that are not configured in the server. The list of extensions
that are not configured are also displayed.
• Consider extension 5001 is already configured at a particular location in the system, say location 1 of
S/W Port No 1. Another extension 5002 with different set of configuration is listed at the same location,
that is, location 1 of S/W Port No 1 in the CSV File, then in this case, when the CSV file is uploaded, the
configuration of the extension 5001 will be overwritten with the configuration of the extension 5002.
• In case, you keep the Extension Number for any extension listed in the CSV File as blank, then, the
system will not create this extension. Moreover, the system will consider it as an end of the list and any
extension/s listed after this blank Extension Number will not be created.
• The total number of extensions the system creates will depend on the number of extensions configured
in System Pre-requisites. For an instance, if you have configured 100 as the SIP Extensions in
System Pre-requisites and upload a CSV File with a configuration of 500 extensions, then the system
will create only the first 100 extensions.
• Make sure the SIP ID and MAC/ Device ID is unique for all the extensions configured in the system. In
case, the SIP ID or MAC /Device ID listed in the CSV File conflicts with the SIP ID or MAC /Device ID of
an extension already configured in the system, then in this case, the extension with the duplicate SIP
ID or MAC/ Device ID will not be created.
• It may take about 3 minutes to create all the 2100 extensions in the system.
• The system will not create an extension listed in the CSV File, if the Extension Number configured for
this extension in the CSV File matches with any of the access codes configured in the system. To know
the access codes that are configured in the system, refer to “Access Codes”.
• Make sure you do not leave the mandatory parameters listed in the CSV Generator Template as blank,
otherwise the system will not create these extensions. All the parameters listed in the CSV Generator
Template are mandatory for creating the extensions.
To configure rest of the parameters which are not mentioned in the CSV File, refer to “Configuring SIP Extension
Settings as per the Extended Phone Type”.
Copy Parameter Values
Once you have created the extensions, you can now configure the parameters which are not mentioned in the CSV
File as per your requirement.
After you have configured the required parameters for an extension, you can now copy the configuration of this
extension to all the other extensions by simply using the Copy button present at the bottom of the SIP Extension
Settings page.
For an instance, you can configure the parameters like DSS Key Settings, Quality of Service (QoS) for an extension
and copy the configuration of this extension to other extensions. To do so,
To Next Page
Loading...