366 Matrix PRASAR UCS System Manual
• Station Advanced Feature Template: Configure this parameter if you have selected Station as the Treat
Incoming call as option. Assign a “Station Advanced Feature Template” to the SIP trunk. There are 50
different templates to choose from. Each template can also be altered to suit your requirement and
preferences. Default: Template number 01 assigned to all SIP trunks.
Outgoing Call
• Allow OG Calls without Registration: This parameter is to be enabled to allow outgoing calls to be made
from the SIP trunk, even when the SIP trunk is not registered. If this check box is disabled the system will
not allow outgoing calls to be made if the status of the SIP trunk is 'not registered'. By default, this check
box is disabled.
• Send CLI in FROM field: This parameter allows you to configure the CLI of the SIP Trunk to be sent to the
remote party on outgoing calls made using the SIP trunk. You may select any of the following options as
desired:
• CLIR: Select this option if you do not want the CLI to be sent.
• SIP ID: You may select this option if you want the SIP ID configured on the SIP Trunk to be sent as
CLI.
• Calling Party Wise: Select this option if you want to send the Calling Extension Number (the number
of the extension making the outgoing call through the SIP trunk) as CLI.
When reverse DDI is programmed on the SIP Trunk, the DDI number of the calling extension will be
sent, instead of its extension number.
If the calling extension has disabled the parameter ‘Send DDI as CLI’ in its Station Advanced Feature
Template, then its Pilot number configured in the Outgoing Reference Table will be sent as CLI.
If calling extension has enabled CLIR, no CLI will be sent on the SIP Trunk.
• Fixed Number: Select this option if you want a specific number to be sent as CLI. When you select this
option, you must also define the number to be sent as CLI.
You may select this option if you wish to send any of your trunk line numbers as CLI on the SIP Trunk
so as to enable the called party to call back the calling party using this CLI.
To Next Page
Loading...