Matrix PRASAR UCS - Page 382

Matrix PRASAR UCS System Manual 373
• Type: Select the type of Call Budget on Trunk—Amount or Minutes or Calls—to be applied on this SIP
trunk. By default, no Call Budget type is selected.
• Amount: If you selected 'Amount' as the Call Budget Type, enter the Budget Amount in this field. By
default the Amount is set to 99999.
• Minutes: If you selected 'Minutes' as the Call Budget Type, enter the number of Minutes in this field. By
default the number of minutes is set to 99999.
• Calls: If you selected 'Calls' as the Call Budget Type, enter the number of Calls in this field. By default the
number of calls is set to 9999.
• Scheduled Reset: Select this check box to enable, if you want the Call Budget Amount/Minutes/Number
of Calls to be reset on a particular date of every month.
• Scheduled (Date): Select the date of the month (Daily or 1-31) on which you want the Call Budget
Amount/Minutes/Number of Calls to be reset every month. You may select 'Daily' if your plan suggests so.
Call Back
This parameter is related to the “Call Back on Trunk Port’ feature. If you want to enable the 'Call Back on Trunk
Port' feature on this SIP trunk, configure the following parameters:
• Enable Call Back: Select this check box to activate the Call Back on Trunk Port feature. By default, this
check box is disabled (clear) on all SIP trunks. By default, the Check box is disabled.
• Call Back Timer: This is the duration for which the system waits for the caller to disconnect before
applying the Call Back. The range of this timer is from 01 to 99 seconds. By default, it is set to 10 seconds
for all SIP Trunks.
• Call Back Mode: Select from the following options how a ‘Call Back’ call answered by the remote party
should be routed:
• PIN Authentication - Multiple Calls
• CLI Authentication - Multiple Calls
• CLI Authentication - Single Call
• Operator
By default, Operator is selected as the Call Back Mode.