40 Matrix PRASAR UCS System Manual
You can register following UC Clients as SIP Users of the system:
• Matrix VARTA WIN200, Unified Communication Client for Windows. For instruction, refer to the MATRIX
VARTA WIN200 User Guide.
• Matrix Mobile UC Clients, as given below:
• Matrix VARTA AMP100, the Mobile UC Client for iPhones. For instruction, refer to the Matrix VARTA
AMP100 User Guide.
• Matrix VARTA ADR100, the Mobile UC Client for Android Smartphones. For instruction, refer to the
Matrix VARTA ADR100 User Guide.
Refer to “PRASAR UCS Features Supported in Terminals” to know the features supported in each client.
The SIP Users may be registered over WAN or over LAN according to your preference and your IP network
installation scenario. Extended SIP Phones and UC Clients can be registered with PRASAR UCS using IPv4
Addresses only.
You can register the same SIP User from three different locations.
If you register the Extended IP Phone outside the Region/Country selected for PRASAR UCS, the time and
Time Zone dependant features, such as Alarms, Reminders, Time Zone Display, of the phone at each
location will operate according to the Real Time Clock of PRASAR UCS. Also, Access Codes and
Emergency Numbers will work according to the Region/Country selected for PRASAR UCS.
• Connect the Extended IP Phone, or any Standard IP Phone to the LAN Switch.
• Register any SIP device (Extended IP phone/ Soft clients or Standard IP phone) on the public network as
SIP Extension.
• When you register the Matrix Extended IP Phone with the system, the WAN/LAN port is used for Auto
Configuration as well for Registration of the Extended IP Phones.
• When you register a SIP device other than the Matrix Extended IP Phone on the public network as SIP
Extension, do the following:
• In this SIP device configure the following:
• the Registrar Server Address of PRASAR UCS
• the Registrar Server Port
• the SIP ID
• Authentication ID and Password.
• Configure Port Forwarding for the WAN Port of PRASAR UCS on the Router.
If the PRASAR UCS is connected to a Public Network,
• Connect the Matrix VARTA WIN200, Extended IP Phone, or any Standard SIP device to the LAN Switch.
• Register any SIP device (Matrix VARTA UC Clients, Extended IP phone or Standard SIP phone) on the
public network as SIP extension.
To Next Page
Loading...