Matrix PRASAR UCS - Page 582

Matrix PRASAR UCS System Manual 573
Setting the Retry Counts for Authority Code
By default, the system allows three attempts to re-enter the Authority Code Password. If you want to increase or
decrease the number of attempts, set the parameter Retry Counts for Authority Code to the desired value. For
instructions, see “System Timers and Counts”.
How to use
For Extended IP Phone Users
To use Authority Code from any extension:
• Go OFF-Hook.
• Press DSS Key assigned to ‘Walk-in COS’.
OR
•Dial 111
• Select the ‘Walk-in by Authority Code’ option and press the Enter key.
• Dial the Authority Code, followed by the Password.
• You will hear the confirmation tone, followed by dial tone.
• Dial the desired number.
Printing Reports of Outgoing Calls made using Authority Codes
You can print call details of users who made outgoing calls using Authority Codes. For this, you will need to:
• enable Store Outgoing Calls in the Station Basic Feature Template of the extension user.
• set the Calls made using Authority Code filter in Outgoing Call Report.
• configure the destination port for SMDR-Outgoing Call Report.
Refer the section “Station Message Detail Recording-Report”, for detailed instructions on printing reports using
filters.