Matrix PRASAR UCS - Page 655

646 Matrix PRASAR UCS System Manual
This will lead you to the “Number Lists” page. Click '001-250' of Number list 07-08.
By default, Number List 08 is assigned to this parameter. You can also program any other Number List
you want. Enter the list of numbers on which CDC is not be applied (refer to the list you prepared).
Click Submit.
Return to the Call Duration Control page. If you have prepared a Number List other than the default
08, then enter the number of that list in the Do Not Apply CDC for calls matching with numbers
column.
• Apply CDC for calls matching with numbers: This is the list of numbers on which CDC is to be
applied. By default, Number List 07 is assigned to this parameter. You must configure this list with
numbers on which you want CDC to be applied.
To configure the list, click Apply CDC for calls matching with numbers. The 'Number Lists' page
opens.
Click '001- 250' of Number list 07- 08. Follow the same steps as described above for configuring the Do
Not Apply CDC Number List.
• CDC Timer: This is the time for which the warning beeps are to be played before the system
disconnects the call. The range of the timer is 0001 to 9999 seconds. By default this Timer is set to 160
seconds. Set the CDC Timer to the desired time limit.
• Disconnect Call after CDC Timer: This check box is to be enabled if you want the call to be
automatically disconnected on the expiry of the CDC Timer. By default the check box is disabled, which
means that calls will not be disconnected on expiry of the CDC Timer. Enable the check box if required.
• Click Submit.