62 Matrix PRASAR UCS System Manual
• DOMAIN: The Domain Name assigned to the phone.
• 802.1x Authentication: The 802.1x authentication status is displayed—Success, Failure,
Authenticating or Disabled.
• FIRM: The version of the current Firmware of the phone.
• UBOOT: The UBOOT release date.
• KERNEL: The KERNEL release date.
Connecting SPARSH VP330 as Extended SIP Extension
You are recommended to complete the following steps before connecting the Matrix SPARSH VP330 to PRASAR
UCS:
• Decide the location where you want to place SPARSH VP330 within your LAN.
• By Default, in SPARSH VP330, the Connection Type selected is DHCP.
• If you want to use the DHCP Server for assigning IP Address to the Extended IP Phone, select DHCP
option 224 and Data Type as ‘String’ and program the LAN or WAN IP Address /Domain Name of
PRASAR UCS and SPARSH Port in the format “IP_Address:Port” in your LAN DHCP Server as per your
installation scenario.
• Login to Jeeves. For instructions, read the topic
“Configuring Basic PRASAR UCS Settings”.
• You must configure the necessary parameters in PRASAR UCS so that SPARSH VP330 can register as a
SIP Extension. For instructions, see “Configuring Matrix SPARSH VP330”.
Now, follow the steps described below to install SPARSH VP330.
1. Unpack the SPARSH VP330 box and verify package contents.
2. Mount the phone on a desk or wall at a location convenient to you.
• When mounting the phone on the wall,
• Use the mounting template to drill holes of appropriate size and distance. Fix the screw grips in the
holes you drilled.
• Fix two screws in the holes on the wall, ensuring that they are aligned with the Keyhole Slots 1 and
2.
• Use wall plugs, if required, to fix the screws. Leave the screw heads protruding from the wall to fit
into the Keyholes.
To Next Page
