Matrix PRASAR UCS - Page 738

Matrix PRASAR UCS System Manual 729
• Define a new CoS group with CLIR/CLIR Override enabled.
• Prepare a Station Basic Feature Template with this CoS group applicable in all the “Time Zones”.
• Assign this new template to the extensions to which CLIR/CLIR Override is to be allowed.
Refer the topics “Class of Service (COS)” and “Station Basic Feature Template” for detailed instructions and
programming.
How to use
For Extended IP Phone Users
To enable CLIR
• Press DSS Key assigned to CLIR
102
.
OR
•Dial 103-1.
• You get confirmatory tone and message on the phone's display.
• Go idle or you get dial tone after 3 seconds.
To disable CLIR:
• Press DSS Key assigned to CLIR again
103
.
OR
•Dial 103-0.
• You get confirmatory tone and message on the phone's display.
• Go idle or you get dial tone after 3 seconds.
102. System Engineer is recommended to assign a DSS Key with LED to this feature. When the assigned DSS key is pressed, it will
glow red indicating that CLIR is enabled.
103. If a DSS key with LED has been assigned, when you press the key again, the LED will be turned off indicating CLIR is now
canceled.