Matrix PRASAR UCS System Manual 741
• Under Configuration, click CLI Based Routing.
•In Method for matching received CLI, select the method according to which you want the system to
match the received CLI with the numbers stored in the CLI table. You can select:
• Match from last digit of CLI
• Match from first digit of the CLI
The method you select will be applicable to all the numbers configured in the CLI Based Routing Table.
• In the CLI table each number is to be stored at a Location Index numbered from 0001 to 2000.
There are 100 entries on each page. To go to the next 100 Index numbers, click the tabs 0101-0200
, 0201-
0300, 0301-0400 , 0301-0400.................................1901-2000.
• At each Location Index, enter the following parameters:
• Calling Party’s Number: enter the number of the calling party, not exceeding 16 digits. You can also
enter '+' in the number string.
• Calling Party’s Name: enter the name of the calling party. You can enter a maximum of 8 characters
in this field.
• Destination Type: select the landing destination extension. It may be SIP extension, Routing Group,
Virtual Extension or Voice Mail Auto Attendant.
• Port Number: enter the port number (software port or routing group number) to which the landing
destination is connected. This is applicable for Destination Types — SIP Extension or Routing Group.
If you have selected Virtual Extension as the Destination Type, enter the software port of landing
destination of the Virtual Extension.
If you have selected a Routing Group as the Destination Type, enter the number of the Routing Group
(01 to 96) in this field.
• Voice Mail Auto Attendant (VMAA) Menu: if you have selected the Voice Mail Auto Attendant as the
Destination Type, select the VMAA Menu to be assigned to the respective calling party.
You may click the Voice Mail Auto Attendant (VMAA) Menu link to edit the parameters of desired VMAA
Menu. For details, see “Voice Mail Auto-Attendant Menu”.
To Next Page
Loading...