Matrix PRASAR UCS System Manual 745
• Self-Route: For this application make sure it is disabled. This parameter is relevant when you have the
same extension numbers in each system.
• Dialed Digit Count: When digits are dialed on the trunk, the system waits for inter digit timer after the last
digit is dialed. In order to avoid this timer and number of digits dialed to be routed without further delay,
count for the number of digits to be programmed here. If the number of digits received are equal to the
parameters programmed then the number is dialed out immediately without waiting for the inter digit timer.
If the number of digits dialed by the user are not equal to the digits programmed, the number is dialed after
inter digit timer.
• Apply Toll Control: When Self Route check box is disabled, system will check this parameter.
By default, the Apply Toll Control check box is enabled. The system will apply toll control to all the outgoing
calls. Disable this check box, if you do not want to apply toll control to the CUG numbers dialed by you.
For detailed information, see “Toll Control”.
Apply Call Cost: By default, this check box is enabled and the system will calculate the cost of each call.
For certain calls (internal calls) you do not require the call cost calculation, clear the check box
corresponding to these entries. You can also set the filter Calls with units more than to generate a report
according to the Call Cost. For details, see “Station Message Detail Recording-Report”.
Scenario 2
A network in which you:
• have same extension number in all the systems, that is, extension number 2001 in System-A as well as in
System-B or System-C.
• S1 to Sn are extensions.
• SIP Trunk 1 to SIP Trunk 3 are SIP Trunks connecting the three Systems.
To Next Page
Loading...