748 Matrix PRASAR UCS System Manual
• OG Trunk Bundle Group: An OG Trunk Bundle Group (OGTBG) is assigned to each route code.
Whenever a call is to be made on that route, a free trunk from the OGTBG is selected and the
extension number is dialed on it. The same logic of Rotation On/Off for trunk selection from the OGTBG
is used. If rotation is OFF then always the first trunk in the OGTBG is selected. If it is busy then the next
trunk in the group is selected. This helps to select an alternate route. Whereas if Rotation is ON then
the trunks in the OGTBG are selected in round robin fashion.
• Strip Digit Count: Configure this as per your requirement. Refer to the examples above.
• Self-Route: Configure this as per your requirement. Refer to the examples above.
• Dialed Digit Count: When digits are dialed on the trunk, the system waits for inter digit timer after the
last digit is dialed. In order to avoid this timer and number of digits dialed to be routed without further
delay, count for the number of digits to be programmed in this field. If the number of digits received are
equal to the parameters programmed then the number is dialed out immediately without waiting for the
inter digit timer. If the number of digits dialed by the user are not equal to the digits programmed, the
number is dialed after inter digit timer.
• Apply Toll Control: By default, this check box is enabled. The system will apply toll control to all the
outgoing calls. Disable this check box, if you do not want to apply toll control to the CUG numbers
dialed by you.
• Apply Call Cost: By default, this check box is enabled and the system will calculate the cost of each
call.
For certain calls (internal calls) you do not require the call cost calculation, clear the check box
corresponding to these entries.
• Click Submit.
To Next Page
Loading...